Eventronic Combination of Watch Repair Kit & Watch Press, Watch Tool Kit with Watch Battery Replacement Tool Kit, Watch Back Remover Tool, Watch Link Removal Tool and Watch Press Tool with 12 Dies

Step 1: Note: Most straps have "arrows" that indicate the direction in which the pins are to be pushed out. Please do not go against this direction.

Step 2: Choose the correct size pin for your watch.

Step 3: Don't forget the sponge block. It will help you to adjust the height of the hole by relaxing or pressing.

Step 4: Adjust the circular platform at the bottom of the strap tool so that your punch is parallel to the hole.

Step 5: Make sure the strap is level and everything is lined up.

Step 6: Turn the side wheel and use the punch to push the link pin out into the slit.

How to open a watch case with our watch repair kit?

First, confirm the type of your watch case and select the correct watch case opener before installation.

A. If it is a press-in watch back case, please follow the steps of the first method.

1. Turn the watch back side up and fix it on the watch case holder, and hold the watch case opener with your other hand.

2. Carefully insert the blade into the pry hole of the watch back case and gently pry up the back case.

B. If it is a screw-in watch back case, please follow the steps of the second method.

1. With the back of the watch facing up, secure it to the watch back case holder, adjust the center wheel, and open the pin to the diameter of the watch back case.

2. When the watch case case opener is firmly fixed on the watch back, you can start to turn the watch case opener to open the watch back.

Be careful to hold the watch case holder to prevent it from moving.

How to remove the watch band?

1. Insert the B point (O-head) of the spring bar into the hole on the strap and push out the link pin.

2. Place the point A (V-head) of the spring rod to the connection between the strap and the watch (the end point of the spring bar), and press it in slightly to easily remove the spring bar.

3. Use a CM ruler to properly measure the width of the watch lugs.

4. Choose the proper spring bar size, there are 18 sizes, 3 of each size, 54 in total, including 8mm, 9mm, 10mm, 11mm, 12mm, 13mm, 14mm, 15mm, ... , from 8 mm to 25 mm.

1. Measure the size of the watch dial

2. Choose a mold larger than the dial face and install it on the bottom

3. Choose another mold smaller than the back cover and install it on the top.

4. Press down and then screw and tighten it onto the press machine

5. Lay down the cloth and then place the watch on the mold, making sure it is in the correct position.

6. Press down the handle bar to install the watch case.

2023 Watch Repair Latest Combination Version Includes:

Watch Press Tool

Equipped with 12* dies including 50/48mm, 46/44mm, 42/40mm, 38/36mm, 34/33mm, 32 / 31mm, 30/28mm, 26/24mm, 23/21mm, 20/18mm and 2*special molds.

Watch Repair kit

1*Watch case opener & 1*Watch case holder,

1* Watchband holder,

1* tweezers,

1* dual head hammer,

1* metal watch link removal tool with 6 extra replacement pins

2*Spring bar tool,

3*Pin punches,

1*watch case opener,

1*Sponge block,

1*Glasses cloth,

54*Watch spring bar.

In this version, we have made more upgrades of the watch tool kit contains update different tools to meet your watch repair needs. For example, we have watch press tool! Don’t worry, it is Easier than you think.