DAYUAN Ball Joint Press & U Joint Removal Tool Kit with 4x4 Adapters for Most 2WD and 4WD Cars and Light Trucks

To Remove a Ball Joint

1. Assemble the Ball Joint Press (1) over the vehicle's control arm. Select the correct size Receiving Tube (3,4,or 5), and position it under the vehicle's ball joint.

2. Place the Removal Adapter (7) between the Receiving Tube and the Jackscrew (2).

3. Then, place the Installation Adapter (6) between the top of the ball joint and the Ball Joint Press.

4. Tifhten the Jackscrew until the Receiving Tube contacts the vehicle's control arm.

5. Check the alignment of all the Ball Joint Kit parts, and continue tightening the Jackcrew until the vehicle's ball joint is removed.

To Install a Ball Joint

1. Clean the vehicle's control arm, and coat the inside diameter of the control arm with a light lubricant.

2. Insert the replacement ball joint as straight as possible into the vehicle's control arm.

3. Assemble the Ball Joint Press over the vehicle's control arm. Select the correct size Receiving Tube and position it on top of the vehicle's control arm.

4. Place the Installation Adapter between the Receiving Tube and the Ball Joint Press. Then, place the Removal Adapter between the ball joint and the Jackscrew.

5. Check the alignment of all the Ball Joint Kit parts. Then, tighten the Jackscrew until the vehicle's ball joint is firmly sealed.

To Remove and Install Brake Anchor Pins

1. To remove the brake anchor pins, remove all lock ring retainers from the Brake Anchor Pins.

2. Position the Ball Joint Press over the brake spider.

3. Tighten the Jackscrew until the anchor pins can be removed.

4. To install the brakke anchor pins, insert the brake anchor pins. Then reinstall the lock ring retainers on the brake anchor pin.

5. Unscrew and remove the Ball Joint Press.

To Disassemble / Assemble a U Joint

1. To disassemble a U joint, remove any external and/or internal lock rings.

2. Position the Ball Joint Press around the drive shaft yoke and tighten the jackscrew until the first bearing is removed. Reposition the ball joint press and remove the second bearing.

3. To assemble a U joint, clean all dirt and oil from the yoke area. Align the replacement bearing and Ball Joint Press as straight as possible over the yoke. Press the replacement bearing into the yoke, and reassemble the external/internal lock ring.

4. Reposition the ball joint press and second eplacement beaing as straight as possible over the yoke, and press the beaing into the yoke.

5.Reassemble the external/internal lock ring.