Dash Cam Hardwire Kit, Mini USB Hard Wire Kit Fuse for Dashcam, Plozoe 12V-24V to 5V Car Dash Camera Charger Power Cord, Gift 4 Fuse Tap Cable and Installation Tool（11.5ft

Low Voltage Protection

Set 6 high-precision resistors,Dual power-off protection chip, intelligent low-voltage protection device can read the battery voltage more accurately, When your car's voltage is lower than 11.7V or 11.6V, it will automatically turn off the power. Protect your car battery more effectively.

24 Hours Parking Surveillance

The vehicle hard-wire kit connected to car battery or fuse box power, can uninterruptedly supply power for dash camera for 24 hours. It can even supply power when the car is turned off.

Fuse Puller

One free fuse puller inside the storage box for easy picking.

High Quality Copper Conductor

3.5mm transmission line, high-quality copper core conductor, the dashcam hardware kit is faster and safer to charge

Four Types of Fuses Adapters for Almost All Cars

Comes with Low-profile mini fuse, Mini fuse, Micro 2 fuse, ATO (regular) fuse adapters for you to use whatever your vehicles fuse box requires.

Besides, with the seal wire connectors that will be easy for you to connect, firm connection and prevent short circuit.

Upgraded the 2nd Generation Dash Cam Hardwire Kit

An automatic matching device is set at the mini connector to make the compatibility range wider, such as Apeman Aukey Rexing Vantrue Vava Garmin Dash cam, etc.

Compatible 12 – 24V Vehicles

This hardwire kit accepts voltage from any type of vehicles runs on 12 – 24V, works perfect for car, truck, bus, suvs, or big rig for continuous power.

Compatible With Most Of The Car Dash Cam With Mini USB Input

This mirror dash cam hardwire kit is applied to almost all car Mini USB device (Voltage Between 12-30V), Convert the voltage from 12v to 5v,such as Vantrue dash cam、mirror cam、GPS navigator and radar detector etc, it match most of the car installation.

Find the Correct Fuse Slot

Open the fuse box, find the correct fuse slot for your hardwire kit. If you need to find an ignition switched fuse, put the key in the vehicle, find the fuse which is not lit up while the car is off, and test it by turning the car on to see if it lights up. If your kit requires constant power, turn off the car and remove the key to see which fuse slots stays lit on.

Connect the Red Wire

Once you've determined which fuse slots you need to use for your hardwiring kit you can crimp the red wire of your hardwire kit onto the Add-A-Fuse. Gently remove the fuse you identified. Install the fuse you just removed into the installation kit add-a-fuse circuit. Plug the add-a-circuit into the fuse box in the correct orientation.

Ground the Hardwiring Kit

Slip the black wire (which is in the shape of a C) under a metal bolt or screw in your vehicle (this is the ground wire). Check that it is not attached onto plastic parts. You will typically need a socket wrench to loosen the nut or bolt that you choose to ground with. To attach the grounding terminal, loosen the nut or bolt enough to slip it in and tighten it back up afterwards.

DUAL SLOT FUSE HOLDER

It provides one fuse holder to protect original circuit and provides a lead with the second fuse holder for new circuit.